75
ENGLISH
Installation
Unpacking
All transit bolts and packing must be
removed before using the appliance.
You are advised to keep all the packaging for re-use
in case the machine is to be transported again.
Using a spanner unscrew and remove the two rear
bottom screws. Slide out the two plastic pins.
Lay the machine gently on its back, making sure that
the hoses are not squashed.
Remove the polystyrene block from the bottom of the
machine and release the two plastic bags.
Very carefully slide out the left polythene bag,
removing it towards the right and then downwards
Repeat the operation for the right polythene bag,
removing it towards the left and then upwards.
Remove the polystyrene base.
Set the machine upright and unscrew the remaining
rear screw. Slide out the relevant pin.
P1127
P1126
P1124
2
3
1
P0001
P1129
Fill all the holes with the plastic plugs supplied with
the instruction booklet.
Positioning and levelling
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar materials
under the machine to compensate for any unevenness
in the floor.
Water inlet
Connect the water inlet hose to a separate tap with a
3/4" thread.
Do not use already employed hoses for water
connection.
The inlet hose is provided with a water stop device,
which protects against damage caused by water leaks
in the hose which could develop due to natural ageing
of the hose. This fault is shown by a red sector in the
window “A”. Should this occur, turn the water tap off
and refer to your Service Centre to replace the hose.
A
P0271
P1051
P0002
P1128
132990080.qxd 01/12/2003 15:45 Pagina 75