PII17GB
35
BUILDING-IN
Building-in features
This dishwasher is designed to be fitted under a kitchen
counter or sink.
In either case, it is essential that the recess dimensions
indicated in the picture are followed.
No further openings for venting of the dishwasher are
required, but only to let the water fill and drain hoses
and power supply cable pass through.
The recess height may be anywhere between 820
and 880 mm from the floor since the dishwasher in-
corporates levelling feet adjustable over a wide range
(max 60 mm).
Adjust the height of the appliance by turning these
feet.
A distance of 2 mm should be allowed between the
top of the dishwasher and the counter top.
Two pads are also supplied
to make sliding-in or slid-
ing-out of the appliance
easier.
Fit the pads by pressing
them on the feet.
Fitting the vapour protecting strip
Screw the vapour protect-
ing strip onto the front part
of the worktop using four
3,5 x 16 screws.
Fitting the sealing strips to the sides of
the appliance
To ensure closer contact
with the adjacent kitchen
units, fit the plastic sealing
strips down both sides of
the front of the machine
before inserting it into the
recess.
Fitting under a counter (kitchen worktop
or sink)
It is absolutely essential that the dishwasher is
disconnected from the electricity supply before gaining
access to any internal component.
Fit the dishwasher into the appropriate housing space
and connect it. Make sure that the water fill and drain
hoses and the power supply cable are not bent or
kinked.
Fitting the panel onto the door
The door on this model is designed for the overlay of
a panel having the following dimensions:
Width:
596 mm
Height:
644 to 714 mm max
Thickness:
20 mm max
Weight:
2 to 7.5 kg max
Note:
The panel height should not be more than what
indicated, otherwise complete opening of the door will
no longer be possible as the panel hits against the
dishwasher plinth.
Mounting of decor panel onto the door
The height of the panel depends on the height of the
plinth of adjacent kitchen units (see kitchen plinth
adjustment).
The panel must be fitted
with a handle, as the dish-
washer handle will be hid-
den by the panel.
Drill the panel with a Ø 2 x
12 bit according to the di-
mensions indicated in the
figure.
Fix the cross bar onto the panel using four 3.5 x 16
screws provided.
If for aesthetic matching the
panel is provided with a false
drawer (fitted or carved on
the panel itself), the two
brackets provided should al-
so be used.
Fix the brackets according to
the measurements shown in
the figure, by using four 3.5 x
16 screws.
Mount the decor panel by in-
serting the two pivots of the
cross-bar into the slotted
holes of the door.
Lift the decor panel until per-
fect alignment with the facia
panel is obtained: if the two
brackets have also been
used, they will automatical-
ly engage in the special
holes provided on the dish-
washer door.
818
÷
878
555
596
600
820
÷
880
II28
max
0
÷
60mm
II07
II19
*
*
550
30
172
596 max
40
596 max
546
=
=
30
40
30
II17
II12
II20
600 mm
600 mm
II25
A
A
A
A
II23
