ZANKER ZKS 5550 I, Инструкция

Страница: 23 / 25

46
Fitting the vapour protection
Screw the vapour protecting strip onto the front part of
the worktop using four 3,5 x 16 screws.
Fitting the sealing strips to the
sides of the appliance
To ensure closer contact with adjacent kitchen units, fit
the plastic sealing strips down both sides of the front
of the machine before inserting it into the recess.
Securing under a counter
Secure the dishwasher to the counter on the front part
by means of two 3.5 x 16 screws provided (see fig. -
point A).
The dishwasher must be secured against tilting.
Therefore, make sure that the counter it is fitted under,
is suitably secured to a fixed structure (adjacent
kitchen cabinets, wall).
Attention!
The sides of the dishwasher must never be
drilled to prevent damage to hydraulic
components.
Adjusting the door balance
After the door panel, the adjustment of the door
balance may be necessary.
The door of the dishwasher is balanced when it is
open in any position.
For this purpose use the two front screws.
- Open the door.
- Remove the caps and screw or unscrew the screws.
In this way the tension of the door balancing springs
is increased or decreased respectively.
- Insert the caps again.
Important!
The weight of the panel should be within the
limits given in "The furniture door"
otherwise balancing the door will not be
possible
INS39en
450 mm
450 mm
II37
A
II100
45
°
II104
A
A A
A
II23