50
GB
Check and clean the outlet of melting
water coming during defrosting regularly. If
it is clogged the melting water gathered can
cause earlier failure as it can go to the insulating
of the appliance.
Clean the melting water outlet with the supplied pipe
scraper that can be seen in the figure. The pipe
scraper has to be stored in the outlet.
Occasionally check the defrost water outlet not to be
clogged up.
The most typical case of clogging up in the defrost
water outlet when you put food wrapped in some
paper into the appliance and this paper contacts back
plate of cooling compartment and freezes to it. If you
remove the food right at this moment the paper will
tear and it can cause clogging up in the outlet by
getting into it. So you are asked to be careful -
because of the above - when placing foods wrapped
in paper into the appliance.
In case of increased demand e.g. during
heatwaves, the refrigerator temporarily happens
to operate constantly - during this the automatic
defrosting is ineffective.
Remaining small ice and frost stains on back plate of
the cooling compartment after defrosting period is not
abnormal.
Regular cleaning
It is recommended to wash the inside of the
refrigerator in 3-4 weeks time.
Household cleaner or soap must not be used.
After you made it no-current wash the appliance using
lukewarm water and wipe it.
Clean the magnet door rubber profile with clean water.
After cleaning plug the appliance to the mains socket.
Dust and dirt collected on the back of the refrigerator,
condenser is recommended to be removed and clean
the evaporative tray on top of the compressor once or
twice a year.
When the refrigerator is not in use
In case the appliance will not be used for a long time
follow these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up of air inside.
Trouble shooting
How to change the bulb
Should the light fail to work you can change it as
below:
Break the circuit of the appliance.
Unscrew the plate screw fixing the lamp cover, then
take the lamp cover off in the direction of arrow and
the bulb can be changed. (Type of the bulb: Mignon
322, 230 V, 15 W, E 14 thread)
