ZANKER ZKM 3013, Инструкция по эксплуатации и сборке

Страница: 4 / 11

12
UNPACKING AND CONTROL
PREPARATION FOR INSTALLATION
hob dimensions: 572 x 502 mm
cut out dimensions: 560 x 490 mm
fig. 1
sealing ceramic glass
worktable
bracket
Please examine the appliance for
any damage sustained during trans-
portation! If the appliance is dama-
ged please immediately inform the
forwarding company before the
appliance is connected. The pack-
ing material should be disposed
properly.
• Cut out worktop to prescribed measurements or
templates (saw exactly along the scribing).
• Check seal for perfect fit and overall cover.
• Lower the ceramic hob into place and align correctly.
In terms of fire protection, the appliance conforms
to Type Y (IEC 335-2-6). Only appliances of this type
may be installed on one side of adjacent upright
furniture housings or walls.
Fastening according to Fig. 1
• Fasten bracket against the underside of the worktop.
• Using a standard or Phillips screwdriver, tighten the
tension clamps evenly starting at the centre and
moving diagonally, until the built-in rim is tight on the
worktop.
• Do not overtighten!
• Do not use an electric or pneumatic screw driver
without an adjustable safety clutch! (pos. 1 - 1.1 Nm)
55
560 –1
490 –1
R 5
1
2