ZANKER KDT10004FB, Руководство пользователя

Страница: 28 / 40

Water softener level Amount of water (l)
2 100
3 62
4 47
5 25
6 17
7 10
8 5
9 3
10 3
In case of the high water softener setting, it may occur
also in the middle of the programme, before the rinse
(twice during a programme). Regeneration initiation has
no impact on the cycle duration, unless it occurs in the
middle of a programme or at the end of a programme
with a short drying phase. In that cases, the
regeneration prolongs the total duration of a programme
by additional 5 minutes.
Subsequently, the rinsing of the water softener that lasts
5 minutes may begin in the same cycle or at the
beginning of the next programme. This activity
increases the total water consumption of a programme
by additional 4 litres and the total energy consumption
of a programme by additional 2 Wh. The rinsing of the
softener ends with a complete drain.
Each performed softener rinse (possible more than one
in the same cycle) may prolong the programme duration
by another 5 minutes when it occurs at any point at the
beginning or in the middle of a programme.
All the consumption values mentioned in
this section are determined in
accordance with the currently applicable
standard in laboratory conditions with
water hardness 2.5mmol/L according to
the 2019/2022 regulation (water
softener: level 3).
The pressure and the temperature of
water as well as the variations of the
mains supply can change the values.
How to set the water softener level
Make sure the appliance is in user mode.
1. Wait until the indicator starts to flash, the
indicator continues to flash and the
remaining indicators are off.
The intermittent flashing of the indicator shows the
current setting: e.g. 5 f pause + 5 flashes =
level 5.
2. Press the programme button repeatedly to change
the setting. Each pressing of the programme button
increases the level number. After reaching the level
10, the count starts again from the level 1.
3. Press the on/off button to confirm the setting.
Acoustic signals
Acoustic signals sound when a malfunction of the
appliance occurs. It is not possible to deactivate these
acoustic signals.
There is also an acoustic signal that sounds when the
programme is completed. By default this acoustic signal
is deactivated but it is possible to activate it.
How to activate the acoustic signal for the end of the
programme
Make sure the appliance is in user mode.
1. Press the programme button immediately.
The indicator
starts to flash.
2. Wait until the indicator continues to
flash and the remaining programme indicators are
off.
The indicator shows the current setting:
• is off = The acoustic signal is off.
• is on = The acoustic signal is on.
3. Press the programme button to change the setting.
4. Press the on/off button to confirm the setting.
AirDry
AirDry improves the drying results with less energy
consumption.
28