2
●
Advanced MCU control pulse width modulated (PWM) technology, high efficiency
operation.
●
Target for Gel, AGM, Conventional lead-acid (WET) and Calcium Batteries.
●
Built in regulator to prevent your battery from being overcharged. Overcharging
occurs when the charge voltage is unregulated. This can result in premature battery
failure.
●
Come with regulator to prevent your battery from being under charged, in the solar
energy field, battery undercharge always occurs, especially on some Conventional
lead –acid or Calcium batteries; The unit provides an automatic Equalization feature
for deeply drained Conventional lead acid battery or Calcium battery.
●
Can be connected to the battery permanently to keep the battery fully charged by
using a process called “floating”. This means the controller will stop charging when
the battery is full and will automatically start charging the battery as required. This
process will also reduce water loss and help prevent the battery from ‘drying out’.
●
Protects your battery from discharge at night. Under low light or no light conditions
the solar panel voltage could be less than the battery voltage. The unit contains a
special circuit which prevents current flowing back from the battery and into the
solar panel.
●
Colored LED’s to easily indicate the charging status and battery conditions and
system faulty.
●
Multi charging protections against reverse polarity, short circuit, over temperature,
over voltage, etc.
●
Conformal-coating circuit boards and plated terminals apply to hostile environments.
●
Waterproof with IP67 .
For use with 12Volt Solar Panel Only
Suitable for Solar panels up to 135 Watts
FEATURE
