SPECIFICATIONS
• Surface-mounted
• Vandal-resistant zinc alloy housing
• 800 TVL resolution
• ¼” CMOS colour camera
• Night-time IR illumination
• Dust and water proof: IP66
• Operating temperature: -30°C to +60°C
• 110° wide-angle camera
• Video output: 1Vp-p75Ω
• Supply voltage: 10-15 V DC
• Input power: 2.5 W
• Integrated 125 KHz ID reader
• Compliance with Wiegand 26 / ID
• Dimensions: 128x43x16 mm
1. Microphone
2. Camera
3. Night-time IR
illuminator
4. RFID proximity
reader
5. Call button
6. Speaker
INSTALLATION
1. Use the wiring connection diagram and verify
that all wiring connections are correct.
2. Choose a suitable location in which to install
the entrance panel. An installation height
between 1.5 and 1.6 m above the ground
is recommended.
3. The entrance panel video camera should be
away from direct sunlight and deep shadows.
4. Verify that the power supply voltage is OFF
before wiring the device.
5. Switch on the supply voltage of the device
when completely installed.
6. Seal the back plate edges of the entrance
panel of the complete installation surface with
a waterproof silicone product during
the installation. This will prevent condensation
occurring between the entrance panel and
its installation surface in certain weather
conditions. Condensation on the surfaces
causes a risk of corrosion of the electronic
components in the device and mechanical
stress from freezing of the condensation
at low temperatures.
PRODUCT DESCRIPTION
INSTALLATION DIAGRAM
A. Directly on a wall or a post
1. Select the installation height
of the entrance panel and drill the mounting
holes on the installation surface
at the desired height.
2. Remove the bracket by removing
its lock screw.
3. Mount the bracket on the installation surface
with wall plugs and their screws.
4. Pass the connection wiring end through the
bracket and connect it to the entrance panel
wiring. Follow the wiring connection diagram.
5. Install the entrance panel on the bracket with
the lock screw.
B. Directly on a wall or a post with
the 30° angle console
1. Select the installation height of the entrance
panel and drill the mounting holes on the
installation surface at the desired height.
2. Mount the 30° angle console on the installation
surface with wall plugs and their screws.
3. Remove the factory bracket from the entrance
panel back plate.
4. Install the removed bracket on the 30° angle
console with the screws provided.
5. Pass the connection wiring end through the
bracket and connect it to the entrance panel
wiring. Follow the wiring connection diagram.
6. Install the entrance panel on the bracket with
the lock screw.
WIRING CONNECTION DIAGRAM
1
2
3
4
5
6
Wiegand 26 wiring
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
1
2
3
4
5
6
7
8
9
10
Red
Blue
Yellow
White
Orange
Green
Brown
Purple
Grey
Black
Red
Blue
Yellow
White
Orange
Green
Brown
Purple
Grey
Black
Red
Blue
Yellow
White
Orange
Green
Brown
Purple
Grey
Black
Wiegand
26 reader
ELECTRIC CATCH
Power +
Power -
Power
(12V DC)
Power +
Power -
Power +
Power -
Power +
Power -
Power +
Power -
ELECTRIC CATCH
ELECTRIC CATCH
NO wiring
LOCK_Power
(5V~24V AC/DC)
CARD_Power
(12V DC)
NC wiring
LOCK_Power
(5V~24V AC/DC)
CARD_Power
(12V DC)
DISPLAY
DISPLAY
DISPLAY
