RETRANSMITTER RTN-01
MANUAL INSTRUCTION
The device is designed for
single-phase installation
and must be installed in
accordance with standards
valid in a particular country.
The device should be con-
nected according to the de-
tails included in this operat-
ing manual. Installation, connection and control
should be carried out by a qualified electrician
staff, who act in accordance with the service
manual and the device functions.
In case of casing dismantling an electric shock
may occur, and the guarantee is lost then.
Before installation make sure the connection
cables are not under voltage. The cruciform
head screwdriver 3,5 mm should be used to in-
stal the device. Improper transport, storage, and
use of the device influence its wrong functioning.
It is not advisable to instal the device in the fol-
lowing cases: if any device part is missing or
the device is damaged or deformed. In case of
improper functioning of the device contact the
producer.
CAUTION!
APPEARANCE
TECHNICAL DATA
RTN-01
Input rated voltage: 230 V~
Input voltage tolerance: -15 ÷ +10 %
Nominal frequency: 50 / 60 Hz
Nominal power consumption: 0,45 W
Optic signalling of supply voltage: LED green diode
Maximum load current of socket output: 16 A
Transmission: radio 868,32 MHz
Coding way: unidirectional
Coding: addressing transmission
Maximum number of transmitters: 32
Range: up to 250 m in the open area
Optic signalling of transmitter’s operation: LED red diode
Ambient temperature range: -10 ÷ +55
o
C
Operating position: free
Casing mounting: 230 V~ socket
Casing protection degree: IP20 (EN 60529)
Protection level: II
Kategoria przepięciowa: II
Pollution degree: 2
Surge voltage: 1 kV (EN 61000-4-5)
Dimensions: 160 x 66 x 90 mm
Weight: 0,180 kg
Reference standard: ETSI EN 300 220-1, ETSI EN 300 220-1,
EN 60950, EN 61000
The symbol means selective
collecting of electrical and electronic
equipment.
It is forbidden to put the used
equipment together with other waste.
Antenna
Optic signalling of power supply
Optic signalling of radio transmission
Programming push-button
230 V~ socket
230 V~ power supply plug
Retransmitter’s
number switch
DESCRIPTION
RTN-01 retransmitter is used to in-
crease radio transmitter signal range
of wireless EXTA FREE control sys-
tem. Up to four retransmitters can op-
erate in a system - it gives the possi-
bility to increase the distance between
a transmitter and a receiver to 1000 m.
The device is equipped with a 230V
AC pass-through socket - every re-
ceiver can be connected to it. The re-
transmitter does not block the socket.
FEATURES
● wider operation range of EXTA FREE
radio devices,
● possibility to cooperate with three oth-
er RTN-01 retransmitters,
● easy mounting in 230V AC socket,
● low current consumption, possibility of
constant work,
● wide range of operation (up to 250 m),
● power supply and radio transmission
are optically signalled.
VER. 004_11.07.2011
ZAMEL
Sp. z o.o.
ul. Zielona 27, 43-200 Pszczyna, Poland
tel. +48 (32) 210 46 65, fax +48 (32) 210 80 04
www.zamelcet.com
, e-mail: [email protected]
