CONNECTION
DESCRIPTION
FEATURES
Radio gate controller ROB-01/12-24V is a universal (any gate manufacturer) opera-
tion controller of garage gates and similar electric drives that enables to control their
operation by means of EXTA FREE transmitters. It is possible to control few things
using one remote control - entry gate, garage gate, room lighting, etc. The device
can be connected to a suitable wire terminal used as an external antenna.
● cooperation with wireless EXTA FREE system transmitters,
● operation control of entry gates, garage gates, and other electric drives,
● universal low-voltage power supply (12-24V ~/ ),
● 1 remote control can be used for different drives (entry gate, garage) where
ROB-01/12-24V device is mounted,
● connection possibility of external wired antenna,
● wide range of operation (up to 250 m),
● possibility of increasing operation range by means of RTN-01 retransmitter.
12 ÷ 24 V
~/
~/+
~/–
EXISTING
GATE
CONTROLLER
MOUNTING, FUNCTIONING
REMOTE CONTROLS PROGRAMMING
1. Disconnect power supply by the phase fuse, the circuit-breaker or the switch-
disconnector combined to the proper circuit.
2. Check if there is no voltage on connection cables by means of a special
measure equipment.
3. Connect the cables to ROB-01/12-24V device terminals in accordance with the
installing diagram.
4. Switch on the power supply from the mains.
The ROB-01/12-24V device should be mount-
ed in the connection place of manual gate drive
release. The receiver operates in impulse mode
- after receiving a signal from a programmed trans-
mitter it short circuits relay output terminals (11-14)
for about 0,5 seconds.
To improve device operation range it is possible to connect an additional external
antenna to ANT terminal. A connecting cable of maximum section 2,5 mm2 can be
the antenna.
Press PROG push-button of ROB-01 device for a longer time till LED red diode
switches on (constant signal). Next release PROG push-button.
Press the transmitter’s push-button for a longer time. LED red diode switches on
(first signal pulsates, next the signal is constant).
Release the transmitter’s push-button. LED red diode switches on (signal pul-
sates) and then switches off - THE TRANSMITTER IS ADDED.
An exemplary programming procedure with the use of P-257/2 remote controller. The
procedure for the rest of radio EXTA FREE transmitters is analogous.
CAUTION: Every transmitter can cooperate with ROB-01 in a different mode,
depending on how they were added to the device. One transmitter can be added
during one programming cycle. Full memory is signalled with pulsating LED red
diode.