www.zalman.co.kr www.zalmanusa.com
10
VGA Heatpipe Cooler
7. Locate where the Back Side Heatsink Base Assembly is to be Installed
1) The arrow (BACK ) should be pointing in the direction of the slot connector when the Back
side heatsink base is facing in the appropriate direction, as shown in the diagram below.
(Be sure to confirm the positioning. This is very important.)
2) Unscrew the Bolt-D half a turn, and rotate the plate spring so the nipple protrudes through
the hole of the plate spring. (Note: Do not unscrew the Bolt-D completely!)
3) After the Back Side Heatsink Base Assembly is in place, tighten the Bolt-D.
8. Install the Back Side Heatsink Base Assembly
1) Tighten the Nut-A onto the nipple that now has the plate spring in place.
2) Make sure that the two heatsink base assemblies are symmetrically placed in reference to the
graphics card, then tighten the Bolt-D completely.
Nipple
Nut-A
Bolt-D
Nut-B
Nipple
Nut-A
Bolt-A
Groove for Heatpipe
Back Side Heatsink Base
Groove for Heatpipe
Back Side Heatsink Base
(O) (X)
Back
Slot Connector
Front
Back
Front
Back
Rubber Ring
Rubber Ring
Plate Spring
All manuals and user guides at all-guides.com
