6.5) Install the FHS Assembly
Align the FHS Assembly’s base on the
center of the VGA Chipset. Screw each
Bolt ‘A’ on each Nipple ‘A’ slightly, and
tighten each Bolt ‘A’ a few turns at a time,
alternating between each bolt, until the
Clip is completely attached to each
Nipple ‘A’.
Note)
Make sure that the heatsink's base and
the VGA Chipset are completely in
contact with each other.
1) Bolt ‘A’
2) FHS Assembly
3) Clip
4) Nipple ‘A’
5) VGA Chipset
6.6) Install the VGA Card
Insert the assembled VGA
card into the motherboard’s
AGP (or PCIe) slot.
Use the Fixing Bolt to fix the
VGA card onto the computer
case.
If the VGA card has a power
connector on it, remember to
plug in the power cable.
1) Fixing Bolt
2) AGP Slot
6.7) Supply Power to the Fan
Connect the Multi-Connector to the
power supply’s 4-pin connector as
shown in the diagram.
1) 12V
2) FS-V7 Fan Connector
3) 5V
4) Multi-Connector 3-Pin
5) Multi-Connector 4-Pin
6) Power Supply
4-Pin Connector
Quiet Mode (5V)
Performance Mode (12V)
Speed
2050 rpm
±
10%
3,500 rpm
±
10%
Noise
23.7 dB
±
10%
36 dB
±
10%
