Installation / Removal of FHS
3-Pin CPU Fan
Connector
3-Pin Connector of the Fan
Mainboard
Speed
Control Knob
FAN MATE 1
4. When removing, press the upper ends of the clips with
the no-slip surface at a 45-degree angle to separate the
clips from the Retention Guide as shown above.
* Supplement
: If the CPU temperature exceeds 70°C
even after properly installing the heatsink, add
reinforcers under the two sides of the clip.
5. Install the FAN MATE 1 as shown above.
1. Spread the thermal grease thinly onto the
CPU core’s surface that comes in contact
with the FHS.
2. Lightly place the heatsink on the CPU.
3. Insert one end of each of the two clips into the holes on the
Retention Guide. Then press the other ends of the clips
downwards simultaneously to finish the installation. Try moving
the FHS around with your hand to see that it is properly installed.
Thermal Grease
Retention Guide
FHS
Clip
Clip
Rein forcer
CPU
