1. Plug the coffee maker’s electrical cord to the power outlet. Make sure that the cord is
not compressed in any way and so that it doesn’t accidentally move the cooker.
2. Open the tank cover and fill the tank with water. The numbers on the tank indicate the
amount of water needed to fill a specific amount of coffee cups: the left side corres
-
ponding to small cups, the right side to large cups. Fill the tank to maximum if you wish
to make a full pot of coffee.
3. Open the filter cover and lift the filter out. The supplied filter is washable and can be
used many times over. Should you prefer, you can also use ordinary paper filters. In
that case, remove the supplied plastic filter from the device. Add a suitable amount of
coffee powder to the filter and place it in the filter stand. Close the cover.
4. Place the pot on the warmer.
5. Set the clock time and start brewing coffee in the way you desire (a or b).
Setting the time:
After plugging the power cord to the outlet,
set the time with the hour and minute but
-
tons.
a: Timer mode:
After setting the time, you can set the timer
function on and the device will start brewing
coffee at the time set. In this way, you can
enjoy a hot cup of coffee the moment you
wake up the next morning!
• Press the
timer
button. The green LED will
Hours
Minutes
Timer
Start
blink.
• When the green LED is blinking, set the
time you wish the cooker to start brewing
coffee.
• After setting the timer, press the timer but
-
ton a second time to confirm.
For example: if you at 10PM set the timer to
start brewing at 7AM the next morning, you’ll
have the coffee ready at about 7:15AM!
NOTE!
Make sure that the water tank and
the filter are filled before setting the timer!
b: Normal mode:
When you wish to make coffee immediatly,
fill the tank with water and the filter with cof
-
fee powder. Set the pot on the warmer and
press
Start
twice, until the red LED shines.
After the brewing has completed, the pot will
stay warm on the warmer for up to 2 hours.
Shut off the device by pressing
Start
so that
all LED’s go dark.
Operation
