Air drying your towel after finishing your shower routine:
1.
Set the lid vertically onto the flat sidewall on the backside of the towel warmer with the hook
positioned towards the inside of the tub.
2.
Hang your towel from the top towel hanging hook to air dry for it’s next use.
CARE & MAINTANENCE
Remove the power cord from the electrical outlet before cleaning!
•
Wipe with a dry cloth.
•
Do not use chemical agents as they may discolor the inner tub.
TROUBLESHOOTING
Issues
Possible Causes
Solutions
Unit will not turn on.
The appliance is
not activated.
Ensure that the unit is properly plugged into
a wall outlet.
Taking a long time to
reach optimal heating
temperature.
Towels are damp.
Be sure to only use dry towels; using damp
towels will greatly extend the preheating
cycle.
If the following problems are encountered, follow the instructions above.
If the problem persists, contact customer service at 800-468-4348, 714-892-9200
or email [email protected].
FCC NOTICE
WARNING
: Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
NOTE
: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This unit generates, uses
and can radiate radio frequency energy and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try and correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
•
Consult the dealer or an experienced radio/TV technician for help.
