1
2
To use for a shoulder mounted configuration, screw the Sony Rod Stud
into the camera handle’s front 1/4”-20 hole as shown below.
1
To use for a tripod mounted configuration, screw
the Sony Rod Stud into the camera handle’s rear
1/4”-20 hole as shown below.
If you’re unable to focus using the red focus ring, then use
the provided extender frames as shown.
When using the
diopter wheel for fine focus tuning use letters in
menu screen.
Tighten
Loosen
3
Loosen screws and rotate sun mask until
all three notches align with screws.
Remove sun mask by lifting up and insert
your desired diopter, convex side down.
Place sun mask back on top of diopter. Rotate sun
mask to original position and tighten screws.
1
2
To remove extender frames,
press down in middle and pull away
For additional focus range insert drop in diopters as shown below. To insert Lvl 2
Anti-Fog Shield see diagram below. (+4 through -1 Diopters are sold separately.)
Ne
arsighted
Farsighted
Lvl 1 Anti-Fog
Coated Diopter
Concave
Convex
Sun Mask
Lvl 2 Anti-Fog Shield
Slide Z-Finder Rod Adapter onto the
Sony Rod Mount and tighten lever
*Sony Rod Mount may be smaller than
15mm and requires lever to be overtightened.
2
Slide Z-Finder Rod Adapter onto the
Sony Rod Mount using the front rod
port in the rod adapter and tighten lever
*Sony Rod Mount may be smaller than
15mm and requires lever to be overtightened.
Front Rod Port
Assembling Z-Finder with Sony Rod Stud for Shoulder Rig
Assembling Z-Finder with Sony Rod Stud for Tripod
Operating Sony FS5 Z-Finder
