ZCube-SC User Guide
DOC-USR-0265-01
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
36
Verify the status light has stopped blinking green. Click the eject icon
and wait for prompt. The
disconnect the storage device to ensure that all buffered data is completely transferred.
Note:
If less space is available on the storage device than the
Max File Size
specified in the user
interface, the oldest files will be removed until there is sufficient space or no files remain. This check
for available space is performed when start is clicked and every time a new file is created.
(10)
You can verify your recording by connecting the storage device to your PC and opening the newly
created .ts file in VLC media player.
Note:
The PC should be at least a quadcore or 8-core PC. If the PC is too slow, frame skips and possibly video
artifacts will be observed upon playback. VLC should be version 2.1.3 or newer.
6.9
Dual Stream and Record
Dual streaming and recording to .mp4 file simultaneously is supported in RTP, RTSP, UDP, TSRTP, RTMP,
and RTMPS modes. In UDP and TSRTP mode support recording to .ts file when low latency transport
stream is disabled (advanced setting).
(1) Go to CH1 tab and select RTP, RTSP, UDP, TSRTP, RTMP, or RTMPS as the output format.
(2) Set Aux File Enable to MP4File.
(3) Set Output Device and File Prefix as described in section 6.8 steps (6) and (7).
(4) Click start and repeat steps on the CH2 tab.
To activate the special case of stream and store to .ts file with UDP or TSRTP.
(1) Go to the System Setup tab and check the Advanced Settings checkbox. Click Save at the bottom of
the page.
(2) Go to the CH1 tab and select output format of UDP or TSRTP.
(3) Set
TS Lowlat Mode to False.
(4) Select TSFile form the Aux File Enable dropdown.
(5) Set Output Device and File Prefix as described in section 6.8 steps (6) and (7).
(6) Click start and repeat steps on the CH2 tab.
