FV2K-1XA User Guide
DOC-USR-0262-05
______________________________________________________________________________________
Z3 Technology, LLC
♦
100 N 8
th
ST, STE 250
♦
Lincoln, NE 68508-1369 USA
♦
+1.402.323.0702
83
Sample Rate
48000 Hz
44100 Hz
32000 Hz
16000 Hz
Sample rate of audio.
Bit Rate
12
–
384 Kbps
(128 Kbps)
Target bitrate for audio encode.
The bitrate range for AACLC is 12-
384 Kbps (though 64 Kbps or higher
is recommended for best results).
The bitrate range for AACHE and
AACHE V2 is 32
–
64 Kbps.
Source
MIC Line-In
MIC
Select
MIC Line-In
when using a
non-powered/non-amplified
microphone.
Select
MIC
when using a
powered/amplified microphone.
Multicast IP*
(RTSP Only)
w.x.y.z
225.1.2.3
Used to specify the default
multicast address for audio rtsp
stream.
Rtp Port (RTP Only)
0
–
9999 (
8700
)
Destination port for RTP audio.
Pid
*
(UDP/TSRTP/TSFILE Only)
0
–
8191
(120)
Audio PID for transport stream.
Max PTS-PCR
*
(UDP/TSRTP/TSFILE
Only)
0
–
8191
(250)
Maximum difference between the
PTS and PCR in the audio stream. It
is generally recommended to leave
this value at 250. Certain decoders
may require a value similar to the
video delay. If an issue is
encountered with a specific
decoder, try setting this value to
the same value as the video delay.
Output Setup
Output Format
RTP
RTSP
UDP
TSRTP
TSFILE
RTMP
RTMPS
MP4
Output format of the encoded IP
stream.
If UDP is selected, don’t forget to
check the value of TS Rate to make
sure it is in line with expectation.
RTP requires an SDP file for the
receiver that corresponds with the
video codec used.
RTSP requires the use of the RTSP
URL.
TSRTP causes streaming of TS over
RTP. This format is required for