0 means disable the PIR motion.
1 means the lowest sensitivity,
99 means the highest sensitivity.
High sensitivity means can detected long
distance, but if there is more noise signal
in the environment, it will re-trigger too
frequency.
4 Light
Threshold
99
0~100
Setting the illumination threshold to turn
on the light. When the event triggered
and the environment illumination lower
then the threshold, the device will turn
on the light.
0 means turn off illumination detected
function. And never turn on the light.
1 means darkest.
99 means brightest.
100 means turn off illumination detected
function. And always turn on the light.
Notice:
In none test mode, only the
value in 1 to 99 will enable the
illumination detected function and
update the illumination value.
5 Operation
Mode
0
0~127 Operation mode. Using bit to control.
Bit0: 1 means security mode,
0 means home automation mode.
Bit1: 1 means enable test mode,
0 means disable test mode.
Notice:
Bit0 and bit1 will effect when the DIP
Switch setting to program mode.
If bit1 is enabled, the bit0 is useless.
Bit2: Disable the door/window function.
Bit3: Setting the temperature scale.
0: Fahrenheit, 1:Celsius
Bit4: Disable illumination report after
event triggered.
Bit5: Disable temperature report after
event triggered.
6
Multi-Sensor
Function
Switch
4
0~127
Multi-Sensor function switch. Using bit to
control.
Bit0: Disable magnetic integrate
illumination.
Bit1: Disable PIR integrate Illumination.
Bit2: Disable magnetic integrate PIR
(Default is Disable)
Bit3: When Bit2 is 0 (Enable), the device
is install in the same room with the light?
0: In the same room(Default),
1: In the different room.
Bit4: Disable delay 5 seconds to turn off
the light, when door/window closed.
Bit5: Disable auto turn off the light, after
door/window opened to turn on the
light.
Bit6:Enable temperature monitoring.
When this bit enable, the temperature
changed 3 degree Fahrenheit, it will
report.
And also the temperature over 140
degree Fahrenheit, it will report every 64
seconds.
Notice:
If bit2 is zero, this setting is
useless.
8 PIR Re-Detect
Interval Time
3
3~127 In the security mode, after the PIR
motion detected, setting the re-detect
8
Содержание TSM02
Страница 5: ...5...
