Z GRILLS ZPG-10002B, Руководство пользователя

Страница: 10 / 24

8
3.MOUNTING THE HOPPER TO THE CHAMBER
1.Open the Lid, insert the Hopper into the Chamber, then using the Bolts (G) and Gaskets (H)
install it in sequence from inside. Note: the upper pair of Bolts and Gaskets need to be
threaded through the Grease Drain Pan Support (46).
2. Locate the RTD plug-in connector coming from the mounted RTD inside the grill frame.
Connect this with the mating connector located on the outside of the hopper burner
assembly. NOTE: excess wire on the RTD plug should remain outside the Chamber.
4.ATTACHING THE SMOKE STACK AND CHIMNEY CAP
1.Align the holes in the Smoke Stack (15) with holes in the Smoke Stack Gasket (14), which
fits between the right end of the Grill and the Smoke Stack Gasket (14). Insert the Hexagon
Bolts (B) through the holes in the Smoke Stack (15) and the Smoke Stack Gasket (14).
2.Place a Gasket (H) on each Bolt (B) and secure with Hexagon Nut (I).
3.Install the Chimney Cap (16) to Smoke Stack (15).Note that the Chimney Cap (16) is
vertical and then tighten.