09538 Spectrum Z510 Quick Start Guide
www.zcorp-users.com
R
EMOVING THE
P
ART
1. Wait for part to complete printing. Check
software for part orientation.
2. Gross depowder the part and remove from build
area.
3.
Fine depowder part and post-process as
needed.
U
SEFUL
T
IPS
P
ART
S
ETUP AND
P
OST
-P
ROCESSING
Do not tightly pack parts into the build. Keep in mind that you will need to depowder and
remove them from the build box. Allow a little room around the part so you can vacuum
the powder away and get your fingers around or under it.
Orient parts so delicate features are supported in the z-axis, i.e. keep the attaching
feature directly below the fragile features. If a delicate feature is only supported by
unprinted powder the chances of breaking that small feature during depowdering is
greatly increased.
When building delicate parts use the “Fixture” function to cradle the part. Raising the part
0.25" (6.4 mm) from the bottom of the build and creating a fixture under the part will
produce a cradle that can be handled. The part inside the cradle can easily be
transported to an oven or the depowderer.
Do not enable the bleed compensation feature if you are building a part with features
under 0.050" (1.27 mm). Enabling bleed compensation may reduce the feature size.
1.1.1
PART SETUP, ORIENTATION, AND PRINT SETTINGS
