
Technology Center - Technical Service Department
Model 3 Power Frunk installation instruction
Installation steps
1.Remove the hood trim to remove the trim at the
point indicated by the arrow
2.Remove the hood trim to remove the A/C inlet
4.Remove the hood strut then remove the back
sheetsteel of the top of the strut
(same operation left and right)
1
2
3
4
5
6
7
3.Remove the hood trim first remove the locking
block trim and buttons in the trunk,
remove the screws at the markings, 7 screws in total
6.Install the hood bracket after July 2021
Remove the original hood bracket and replace our
matching bracket (same operationleft and right)
5.Install hood bracket before July 2021The picture
below shows (without pedestrian protection)
Bracket installation diagram
(Note: install L to codriver, R to main driver)