Electricity extractor
Principle diagram
Ensure the inlet connected to the
commonly usedoriginal vehicle fuse hole
with power
，
otherwise, the original fuse
overcurrent willfuse,measure with a test
pencil before installation to ensure the
power inlet.The current direction is
shown as the red line in the diagram
Usage
operating instruction
Power inlet
Power inlet
Power outlet
plug in the original vehicle
(no fuse,no plug)
Power frunk special fuse
(match 25A )
Hood button
Phone
Key
/
Open
Close
single click
single click
single click
single click
single click
double click
double click
Center console screen
一：Height adjustment
Adjust the hood to the right height, long press the reset button of the main box for 5 seconds,
and hear a long beep, the height setting succeed, when opened again will be the set height.
Adjust the hood to the right height, long press the reset button of the main box for 5 seconds,
and hear a long beep, the height setting succeed, when opened again will be the set height.
二：Speed Adjustment
Note: Installation instruction may differ slightly from the actual operation, if different,
please operate according to the actual situation or contact us.
**
**
The hood switch speed has 5 gears, default 4th gear, minimum 2nd gear, maximum 6th gear.
Press and hold the reset button of the main box, when you hear the buzzer sound 2 times in a row,
it means the speed is set 2 gears successfully, and so on.
Model 3 Power Frunk installation instruction
Technology Center - Technical Service Department
Model 3 Power Frunk installation instruction
Power frunk special fuse
plug in the original vehicle