background image

Specifications & Parameters 

Size: 310X310X92MM

Arm length: 425MM
Motor: KV 935
Battery:11.1V 2200mAh LiPo
Flight Load: 1.3KG
Flight Time: 15—20 minutes
Environment: indoor & outdoor

310mm

3

1

0

m

m

9

2

m

m

1

1

7

m

m

Transmitter Stick Operation

Diagrams of Flying Operations

Throttle stick (AB):

 The throttle stick controls the up and down of the aircraft. When 

the throttle stick is at the mid point, the aircraft hovers in the air. pushing the throttle to 
A, the aircraft ascends and pulling the throttle to B, the aircraft descends.

Yaw  stick  (CD): 

The

 

yaw  stick  is  used  to  adjust  yaw  directions.  Pull  it  to  the  left  and 

the  aircraft  will  rotate  in  the  counterclockwise  direction.  Push  it  to  the  right  and  the 
aircraft will rotate in the clockwise direction.

Pitch  stick(EF):

  The  pitch  stick  controls  the  forward  and  backward  directions  of  the 

aircraft.Pull  it  to

E

  and  the  aircraft  will  fly  forward  ;Pull  it  to  F  and  the  aircraft  will  fly  

backward  .

Roll stick (GH):

 The roll stick controls the left and right directions of the aircraft.Pull it 

toG and the aircraft will fly to the left direction ;Pull it to H and the aircraft will fly to right 
direction

A

B

C

D

E

F

G

H

Unlock motors

Lock and stop motors

power on the aircraft, wait 10 seconds,backlight flashes

(if  you  fly  in  the  outdoor  with  enough  GPS  signal,backlight 
will  flashes  green  after   

)

make  sure  right  switch 

in 

Attitude flight  mode

 ,Pull the left stick to the right bottom and 

pull  the  right  stick  to  the  left  bottom  at  the  same  time  to 
unlock  as  shown.  then  release  the  right  stick,push  the  right 
stick  to  the  middle  bottom  ,waiting  5  seconds  for  system 
System startup 

until 

backlight flashes red (NO GPS signal) or 

f

l

ashes green then  off(with enough GPS signal)

Right Switch

 Push the throttle stick 
from  middle  bottom  to 
start  the  motors  until 
leaving  ground,  then 
keep  the  right  stick  at 
the  middle  point  ,Yo

c a n  fl y  a t  a  c e r t a i n 
height.

 start motors

Flight Mode

Attitude flight  mode

GPS flight mode

1.Power on Aircraft and Transmitter,Observe backlight flash green slowly  start 

,

aircraft  in  Attitude  flight  mode,waiting  5seconds    fly  away  from  ground,then 

,

Pull the GPS switch to the down as shown ,start GPS flight mode. 
2.In GPS mode  functions
     

:During  the  filght  ,you    keep  all  stickes  in  mid  point,it  will 

position  hold  fly

stay there there without moving.
  

:it can fly home and land when it can not receive the transmitter   

  

Fly home

signal because of far distance or  be Disturbed During it fly home,if you want to 
control  aircraft  you  ,should  switch    from   ATTI.    Mode    to    GPS  Mode  or  GPS 
Mode to  ATTI.  Mode .  
     

Pull  the  right  switch  to  the    up 

a s  s h o w n  , s t a r t  a i r c r a f t  i n 

Attitude flight mode. 

Large battery cabin

Can be Placed two 3S 
2200mAh LiPo battery, 
flight time increase to 20 
Minutes

please pull the throttle stick to the bottom and 

  

carry out

L o c k  M o t o r  p r o c e d u r e  t o  s t o p  t h e  m o t o r s  ( Ve r y 
important)  .    pull  the  sticks  to  the  left  and  right  bottom 

quikly

  as  shown  to  lock  and  stop  the  motors.  Power  off 

the aircraft and then remove or replace the battery. 

BE  SURE  to  power  off  the  aircraft  first  and  then  switch 
off the remote. The flying is finished.

NOTE:

1.You should  unlock and start motor in Attitude flight  mode,or you can not start motor .

2.When you switch to GPS Mode ,you find it fly in one direction abnormally  ,you should switch to 

attitude mode quickly , land your  aircraft and carry out compass calibration ,try again.

 

GPS

ATTI

GPS

ATTI

GPS

ATTI

Содержание Seraphi P GPS










Отзывы: