CAMERA CONTROLS
SINGLE MODE
GIMBAL CAMERA TILT CONTRO
L
There is a gimbal tilt mode switch on ST16---S1. When the switch is in up/middle
position, the CGOET gimbal camera is in Angle Mode. Use the slider (C) on the
left side of the ST16 to set the tilt position of the gimbal camera. When the S1 is in
bottom position, the gimbal camera is in Velocity Mode. When the slider (C) is in
the middle position, it means the velocity rate is 0 for the CGOET, and it will stop
tilting up/down. When the slider (C) is above the middle position, the CGOET will
start tilting up. When the slider (C) is below the middle position, the CGOET will
start tilting down. The distance between the slider(C) and the middle position de-
cides the velocity rate, the further distance, the higher velocity it would be.
CAUTION:
You MUST stop recording video in order to take still photos. It will take
approximately 1-2 seconds to capture a still photo and before you can take another.
CAUTION:
ALWAYS stop recording video before turning off Typhoon H to avoid
data loss.
Slider C
12
01
02
03
05
07
08
06
A
04
Gimbal Pan Mode (Follow Mode/Follow Pan
Controllable Mode/Global Mode)
Gimbal Tilt Mode (Angle Mode/ Velocity Mode)
Gimbal Pan Control
Gimbal Tilt Control Slider C
01
02
03
04
05
06
07
08
B
Take Still Photo Button
Start/Stop Video Recording Button
A
:
B
:
Rudder/Yaw Control (Mode 2 and Mode 1)
Throttle/Altitude Control ( Mode 2)
Elevator/pitch control (Mode 1)
Aileron/Roll Control (Mode 2 and Mode 1)
Elevator/Pitch Control (Mode 2)