Yunca Gas LEEDZ INBUILT, Инструкция по эксплуатации, обслуживанию и гарантии

Страница: 15 / 23

09-06-01 Page 15 of 15 op-instruct-leedz-ib.doc
Soot is being
deposited on glass or
logs. There is insufficient
secondary air in the
combustion chamber.
The logs are not properly
positioned.
Incorrect gas pressures. Check the back of the heater for blockages
around the air intake slots.
Check that the clearances around the
heater match those stated in this manual.
Ensure that the front log set is sitting flat
with no bark chips under it and that the
locating pins are in their holes.
Check that the backlog is sitting on its
brackets.
Check and set gas pressure to
manufacturers specifications.
Front burner
extinguishing.
Thermostat not correctly
sensing the room
temperature.
Thermostat knob set to low. Position the thermostat bulb at back of the
heater on fan inlet duct.
Adjust the Thermostat knob up to give
desired room temperature.
Main burners
extinguishing. Flue down draughting.
Flue way blocked
Pilot flame is not large
enough.
Severe down draught. A vacuum in the room causes this.
Turn off heater. Turn off all air
conditioners, expelair fans, other heaters
etc. Open doors and windows to allow
pressure to equalise. Relight heater.
Close doors and windows but not
completely.
Remove blockage.
Check that pilot assembly is correctly
mounted and that the pilot burner flame
hood directs the pilot flame over both
burners and the thermocouple.
If the flame pattern is disturbed during
extreme winds then ensure a
recommended flue cowl has been fitted
and is still in place.