•
Observe objects of interest. The device can only be tuned by rotating the central focusing wheel
(5).
•
At the end of observation switch off the device by pressing the "ON" button, and cover the
lenses with the caps. Place the device in the case.
ATTENTION!
If the device is operated in cold weather and brought in to warm premises, it is absolutely necessary to
carry out the following:
To warm the device, do not remove from the case this prevents the appearance of condensation in
the electronic and optical elements.
It can only be used again after 5 hours.
SPECIFICS OF USING DL AND RX MODELS
Night Vision Binoculars Tracker DL:
When the device is switched on the LCD can be activated for 10 seconds by pressing the "LCD"
button (8) for a short time. The LCD will display information of the current time and the working status of the
illuminator. For the LCD to work continually, it is necessary to keep the "LCD" button (8) pressed for 3-5
seconds.Setting the time: pressing the "LCD" button for 3-5 seconds activates the liquid-crystal indicator;
the button (7) determines the minutes, and the button "IR" (4) the hours. Pressing the "LCD" button
for a short time switches on the indicator and the time is set.
The LCD Readout operates normally at temperatures ranging from -50C to +400C.
Attention!
Do not forget to switch off the device after use by pressing the "ON" button (3). In order
to test that the device is switched off, press the "LCD" button. If the device is switched off, the indicator will
not activate.
Night Vision Binoculars Tracker RX:
The basic complete set of the device is equipped with a doubler additional device on the lenses,
increasing the magnification of the binoculars to x3,5. The binoculars can be used without the doubler. In this
case the characteristics of the binoculars will correspond with the model NVB Tracker LT.
MAINTENANCE
•
Cleaning optical parts can only be done using special cleaner for multicoated lenses, with a soft
cloth. Dust can be removed from the lenses with a soft brush.
•
The body of the binoculars can be coated in Vaseline using a soft cloth.
STORAGE
Keep the device in its case, away from heat and ventilation shafts, in a temperature not less than
+10°C and humidity not more than 70%. If the device is not used for a long time, it is necessary to remove the
element for recharging.
TROUBLESHOOTING
•
The binocular will not turn on…
Check that the battery is installed properly. Install the battery according to the (+) and (-) polarity,
ensuring that the markings on the battery and battery compartment correspond with one another. Check the
battery contact to ensureit is clean and free of corrosion; if necessary, clean the contact. Also, make sure that the
contact spring is not squeezed; it is possible for one to raise it. Be sure that the cover of the battery
compartment has been installed correctly as it may not have been screwed on properly. If necessary, replace the
battery as it may be depleted and ensure that the binocular is in the “ON” position.
•
Distinct black dots appear on the screen…
These dots are minor cosmetic blemishes resulting from tube production processes and do not
interfere with the reliability or performance of the binoculars.
•
The binocular flickers, flashes or “snows”...
The binocular may flicker or flash when used in a bright environment; to correct this, place the caps
over the objective lenses and enter a dark environment. The binocular will restore itself to a natural functioning
