Yuba Mundo Cargo, Руководство пользователя

Страница: 6 / 18

Yuba Bicycles LLC Mundo Cargo Bicycle [ Owner’s Manual ] Page 5
A wheel attachment device that is
not properly adjusted and closed may
allow the wheel to be loose or come
off unexpectedly, causing you to lose
control and fall. Make sure the
wheels are properly attached before
riding the bike.
Carefully remove the bicycle and all accessories from the box to avoid scratching the frame. Check the carton
for loose parts before discarding.
Assembly of the front wheel
Take the front wheel from the box and unscrew the large nuts. Insert the
front wheel into the fork, center the wheel and then tighten the nuts
using a wrench.
Check that the wheels are properly attached. Bicycle wheels are
attached by several systems: threaded axle nuts, a quick-release where
a lever-actuated wheel retention mechanism allows the wheel to be
installed and removed without tools, or a thru-axle where the axle is
threaded through the ends of the frame or fork. Test for proper wheel
attachment. Pick up the bike and sharply hit the top of the tire. The
wheel must not come off, be loose, or move from side to side.
Assembly of the sideloader bars
In order to install the Sideloader bar, you will need to retrieve the small part box and the following parts. Use
Allen key to tighten all the bolts.
2 screws M6x50
2 washers
4 screws M6x16
Position the Sideloader bar under the bike with the open end towards the rear of the bike.
Slide the two sleeves into the seat stays then position the Sideloader bar below the sideloader bar front
insert. Insert the 2 M6x50 and tighten. Insert the 4 M6x16 in the Sideloader rear slot, and tighten strongly.
Fig 1: Sideloader sleeves Fig 2: Sideloader insert Fig 3: Tighten sideloader insert Fig 3: Tighten sideloader sleeve