Yuba Bicycles LLC
elMundo Electric Cargo Bicycle [ Owner’s Manual ] Page 3
4.
TECHNICAL DATA:
EN 15194:2009 | USA CPSC 16 CFR Part 1512
Weight: 26kg (56lbs) including battery
Motor: DC brushless hub motor 200 W (AUS)/ 250W (EU) / 350W
(US) with planetary reduction gears
Battery Pack: Advanced L Polymer with Battery
Management System, 37V 10ah (370 Wh capacity) 3.1kgs (6.8lbs).
Low voltage protection at 28V, discharge temperature limit -15°C
to +55°C (5°F to 131°F).
Controller: PWM (Pulse Width Modulation), LED self diagnostic system, 20 amp overload protection.
Charger: 2 amp smart charger, maximum charge time 6 hrs, charging temperature 5°C to 35°C (41°F
to 95°F)
Interface: Forward magnetic motion sensor with 0 - 4.5 V VPA dial or throttle with light switch
Fuse: 30 amps
5.
ASSEMBLY
Please refer to the Mundo assembly sheet and elMundo assembly sheet regarding the assembly of the bike
and its components.
The elMundo Bicycle carton should contain:
• 1 elMundo Cargo Bike (7 Speed) with electric front wheel installed, electric components mounted and a
battery installed into the frame.
• 1 part box with pedals, stem and Owner’s manual & Assembly instructions.
• 1 small box with electric charger, 2 30 amp fuses, zip ties.
• 3 Ignition lock key attached to the handlebars.
Front wheel:
The front wheel is assembled. But in case you need to remove the front wheel and reinstall
it, please respect the following guidelines. Insert the hub motor wheel into the fork, ensuring that it is
properly seated in the dropout slots. Tighten the nuts on both sides evenly until the wheel is secured. Be
sure to use the torque arm washer (and bolt it to the fork)! Also, it is a very good idea to check the tightness
of the bolts periodically, as they could loosen during use. Tightening torque value is 35 Nm. We stronlgy
recommend placing the bike upside down to remove or insert the front wheel.
Battery:
Locate the keyhole by the controller box and turn the key counter clockwise while pressing in,
this will release the lock pin. Ensure that you keep the key in the “Lock” position until you are ready to ride.
When installing the battery, do not use excessive force, as this could damage the battery or the connection
pins. If there is an outlet near where the bike will be parked, it is not necessary to remove it. However,
avoid leaving the battery out in cold weather, as this could damage the cells and degrade its performance.
Keys:
3 ignition/lock keys are provided, please safely store any keys not in use where you can find
them. Use only one key at a time! It is not uncommon to have customers lose all 3 keys!
