- 11 -
Step 7:
1. Assemble the tongue to the tray, placing the wide end of the tray slot to the front. Use two
M8x25 hex bolts, two M8x30 hex bolts, four 0.27
” long spacers, four M8 hex lock nuts are shown in Fig.7.
Tighten.
2. Assemble two M8x30 hex bolts, four 0.27
” long spacers, two M8 hex lock nuts to the holes on the
right side of the slot in the tray. Tighten. See Fig 7.
Step 8:
1.Align the tray between the end plates. Use three M8x20 hex bolts to temporarily secure three
corners of the tray to the end plates. Leave one upper corner empty. See Fig.8.
2.Rotate the middle brace up against the tongue, aligning it with the holes that are closest to slot in the
tray, fasten the brace to the tongue using two M8x25 hex bots, M8 hex lock nuts. Do not tighten till final
step. See Fig.8.
Fig. 7
Fig. 8
