5. If you need to replace the SIM card with a SIM card for
your own local carrier you can slide the SIM card up
gently to remove it from the holder. Insert a new SIM
card by placing it with the contacts facing the modem
board with the angled notch on the SIM facing the
upper left hand corner (
Figure 8
).
6. Begin reassembly by placing back half of case onto
the front case. Take care to move the antenna cable
back up to the top opening of the case so that it does
not get pinched (
Figure 9
).
7. Slide rubber gasket into place (
Figure 10
) then slide
top mounting plate in place lining up the 4 screw holes
with the holes in the case. Insert the 4 screws and start
them but do not tighten them all the way yet. If screws
are too tight you will have trouble lining up the screws
for the bottom plate in the next step.
8. Flip the Storm over and place the rubber gasket on
the bottom side into place.
Figure 9: Begin reassembly of Storm 3
Figure 8: Replacing the SIM card with one
from your own local carrier
Figure 10: Slide rubber gasket into place
ysi.com/storm3
