7. Press the ‘E’ key on the “Map. End point” option
(
Figure 10
)
8. Enter in the mapping end point (we recommend you set the distance to about 2 feet above the water
surface), highlight the checkmark box and press the ‘E’ key
(
Figure 11
)
9. Press the ‘E’ key on the “Record map” option
(
Figure 12
)
10. Then scroll down and highlight the “Record map” option and press the ‘E’ key
(
Figure 13
)
11. When it is complete it wil return to a “Distance” screen, press the key corresponding with the
checkmark to continue
12. Mapping is complete
3
Figure 10
Figure 11
Figure 12
Figure 13
When a Radar is installed we recommend performing a mapping. As time passes new obstructions may
be exposed and the site may need to be remapped, but multiple mappings can result in bad data. When a
mapping is performed it gets saved in the radar. If a second map gets performed it also gets saved and the
radar tries to honor both mappings resulting in some radar confusion. To avoid this confusion simply delete
the first mapping before performing the second.
To delete a mapping, follow steps 1-5 in the ‘Steps to Perform Mapping’ section, then follow steps 1-6
below.
Steps to Delete a Mapping
1. Follow steps 1-5 in the ‘Steps to Perform Mapping’ section (see page 2)
2. In the mapping menu, press the ‘E’ key on “Confirm distance”.
3. Then scroll down and highlight “Factory map” and press the ‘E’ key. (
Figure 15
)
