Youshiko YC9445, Руководство пользователя

Страница: 8 / 22

Initial operation:

According to the appearance of the Weather Station, the power adapter is inserted from the B11 position, and
the power supply of the power adapter is also noted.

Open Weather Station battery compartment cover, open Weather Station battery compartment cover, insert 2 x
AA batteries observing pola
rity [ “+” and “–” marks]

After the weather station is connected to the power supply according to the above two steps, all the icons on
the LCD display will light up for 3 seconds, you will hear the buzzer, and check the indoor temperature,
humidity and pressure.

The Weather Station will now start to make a connection to the outdoor remote sensor. This operation takes
about 3 minutes and is displayed by a flashing reception RF antenna symbol in the “
OUTDOOR
” display area
on the receiver.

This now, open Wireless Outdoor Sensor battery compartment cover, according to the channel to be set, the
channel of the sensor is set through the shift switch of the C6 position of the sensor, and Insert 2 x AA batteries
observing polarity [ “+” and “–” marks]

When the wireless sensor is loaded into the battery, all the icon on the LCD display will briefly light up for 3
seconds, and detect the temperature and humidity of the sensor, At the same time, LED lights flicker once, the
wireless sensors automatically transmit wireless signals.

When the Wireless Sensor is launched, the Weather Station alarm automatically receives its signal, and the
“
OUTDOOR
” column displays the temperature and humidity values.
F.Y.I.:

The Weather Stations can receive up to 3 channels of wireless sensors.

The conventional wireless sensor displayed by the weather station is channel 1. If the wireless sensor is set to
channel 2 or 3, you need to press the “ ” button on the right side of the weather station to switch to channel 2
or 3, and then check whether the temperature and humidity are correct to confirm whether the signal is
successfully received.
Manual time setting:
 Press and hold down the “ ” button
more than 2 seconds to enter the time and general settings, first set
the b
utton’s BEEP sound
, now use
“▲” and “▼” buttons to set BEEP in ON or OFF.
 Press “ ” to confirm your setting,
switch to temperature unit setting.
Now use the “ ▲ ” and “▼”
button to
set the temperature of the unit, the unit of temperature can be set to “°C” or “°F”
 Press “ ” to co
nfirm your setting, switch to pressure unit setting.
Now use the “ ▲ ” and “▼”
button to set
the pressure of the unit,
the unit of t pressure can be set to “hPa” or “inHg”
 Press “ ” to confirm your setting,
switch to radio controlled clock(RCC) function setting
, Now use “ ▲ ”
and “▼”
buttons set the RCC receive function to activate(ON) or close(OFF)
 Press “ ” to confirm your setting, switch to daylight saving time (DST) function setting, Now use “ ▲ ”
and “▼”
buttons set the DST function to activate(ON) or close(OFF)
 Press “ ” to confirm your setting,
switch to the 12/24 hour mode display setting. Now use
“ ▲ ” and “▼”
buttons to set the time displayed in 12-hour or 24-hour format
7