yourrccompanion.com
Build Companion: Freewing Mig-21 80mm
Copyright 2016 by Brad Miser
Page 23
runs so you can put the light’s wire in it too. The way the red star decal was placed on my
model, I had to lift up the tip of one of the star points to be able to widen the channel. If
you are careful, you can lift it up so it can be easily placed back down again when the
wire is installed.
8.
Solder the wire to the light; like the vertical stabilizer, I only use the positive and
negative leads because I want the lights on all the time the plane has power.
9.
Route the wire in the channel you created. I use clear tape to secure the wire in the
channel.
10.
Make sure the wire doesn’t interfere with the motion of the aileron servo arm.
11.
Route the wire the rest of the way to the wing root; leave enough additional wire so it will
reach into the receiver location; I made it the same length as the servo wires.
