8
Operation
Once all equipments are powered on, it is shown by the blue link LED (refer to below
table). Then system will initiate a wireless link, successful connection of the link will
be shown by the blue link LED (refer to below table). This may take short time
depending on the distance between the units and other environmental factors.
When the initial wireless link has been established, the system will establish a video
link between the transmitter and receiver. Once it has been completed, the blue
video LED will be lit on both units (refer to below table *). If your HDMI source and
display devices support CEC then your source device can simply to control using the
displays remote control.
LED
STATUS
MEANING
Link LED slow flicker (TX, RX, stick)
Power on
Link LED fast flicker (TX, RX, stick)
Establishing link
Link LED lighting (TX, RX, stick)
Established link
Video LED lighting (TX, RX) *
Established video link
TX: FSWH02TA
RX: FSWH02RA
Stick: FSWH02TB
* Stick doesn’t have video LED.
IR
repeater
function
(Only
for
Type
A)
You can control your media source device remotely using the IR function.
Ensure that the internal IR port on the receiver unit is positioned to remote
controller.
1.
Position the internal IR port of transmitter near the IR port of your media source
device.
2.
If internal IR port of transmitter is hard to face your media source device,
connect the supplied external IR repeater cable to the external IR input on the
transmitter unit.
You can control your source device from the display side, using the source remote
controller.
