1. Remove rider seat.
2. Locate and disconnect license plate light and
turn signal connectors.
3. While securely supporting the stock fender
assembly, remove the four bolts securing the
fender assembly to the subframe. Carefully
remove the stock fender assembly making sure
not to damage connectors in the process.
4. Remove left and right turn signals from the
stock fender assembly.
5. Cut the stock license plate light connector from
the stock fender assembly. Be sure to cut at
least a 6” section of wire from the connector.
Removal
Installation
1. Install (No. 2)
070BG-LH-K,
license plate light
onto (No. 1)
14120-FEBKT,
fender eliminator
bracket using (No. 8)
M4X6BHS,
4mm screws.
2. Using the
94785-01-ND
butt connectors
provided in the kit, connect the Yoshimura
license plate light wires to the stock license
plate light wires as follows:
Red -to- Red
Black -to- Black/Yellow
3. Secure and install (No. 1)
14120-FEBKT,
fender
eliminator bracket to subframe using the stock
fender bolts.
4. Install stock rear turn signals onto (No. 4,5)
14650-TSL/R-BKT,
left and right turn signal
brackets using the stock hardware.
5. Install (No. 4,5)
14650-TSL/R-BKT,
left and right
turn signal brackets and (No. 3)
070BG-LPF
,
license plate frame to (No. 1)
14120-FEBKT,
fender eliminator bracket using the (No. 6,7)
M6X16BHS
and
M6X14BHS
, 6mm button head
screws and (No. 9,10)
6MMWASHER,
6MMLN,
washer and nut as shown.
6. Route license plate light and turn signal wires
through the hole in (No. 1)
14120-FEBKT,
fender eliminator bracket and through the lower
rear cowl. Re-connect license plate light and
turn signal connectors.
7. Use the cable ties supplied in the kit to secure
license plate light and turn signal wires.
8. Re-install rider seat.
9. Check for proper function of license plate light
and turn signals and that all brackets and
components are secure prior to riding.
3
8
1
2
3
6
5
10
9
1
4
7
