6. Using masking tape and marker, mark and
mask fender as shown. Cut and trim using a
rotary tool and file edges smooth removing any
burrs.
7. Cut the stock license plate light connector wires
on the stock fender assembly side. Be sure to
cut at least a 6” section of wire from the
connector.
8. Trim keyhole cover as shown. File edges
smooth.
1. Remove rider seat.
2. Remove the four bolts securing seat latch
bracket and set aside seat bracket to access
rear fender nuts.
3. Locate and disconnect brake/tail light, license
plate light, and rear turn signal connectors.
4. While securely supporting the stock fender
assembly, remove the four fender nuts and
carefully remove the stock fender assembly
making sure not to damage connectors.
5. Disassemble the stock fender assembly.
- Remove seat keyhole cover.
- Remove the brake/tail light assembly.
- Remove the upper fender cover.
- Remove left and right turn signals.
- Separate plastic fender from metal fender
support bracket base.
Removal
3
