YO People Counter
User guide
v1.0
page 20/35
Device configuration
Configurable parameters
A few parameters must be set in order to send data to the gateway. The default firmware is
configured in OTAA connection type with predefined
deveui
,
appkey (
OTAA
)
and
appskey
,
nwkskey
(
ABP
).
The configuration of the device is stored in a JSON format file divided into sections:
-
info
(generic, read only): information about the device,
-
lorawan
(generic): configuration data required to connect to the LoRaWAN,
-
ble
(generic): Bluetooth settings,
-
device
(dynamic): individual configuration for a specific device (the structure of this section is
different for each device).
-
detection area
(dynamic): individual configuration for the YO People Counter that detects
counts by various parameters. Depending on the application of the sensor in this section, you
can configure its features.
Figure 26
Definition of positive and negative angles in the detection area. Positive values of the beam angle
are more to the left side from the centre of the device, and negative values are more to the right side of the
threshold. A beam angle equal to zero means the object is in front of the device.
REV 1.0
