6
expansion plugs must be suitable for the type of wall).
Figure 6
-
Take the upper part of the telescopic structure
(structure B) and insert 3 slots onto the 3 screws that
are not completely tightened and then rotate slightly to
fit. (Figure 7).
Figure 7
-
Drive in the fourth screw X and tighten the remaining 3
to allow definitive blocking of the upper part of structure
B.
-
Take the lower part of the telescopic structure C and
insert it into the upper part structure B.
-
Adjust the height and block it using the 8 units screws
G that are supplied. (Figure 8)
Figure 8
Suction version
:
-
Fix the pipe to the hole we made on the ceiling (or
p r e p a r e d a i r e v a c u a t i o n h o l e ) . ( F i g u r e 9 ) .
Figure 9
-
Take the upper part chimney piece and fix it with 4
unit screws G. (Figure 10).
Figure 10
-
Take the lower chimney and fix it with 2 unit screws
G, drive in hood to avoid it down. (Fig.11).
Figure 11
-
Insert the suction unit inside the structure and set in 4
mounting hole, drive in 4 units screw N (Figure 12).
