Yosemite DF-EFP148, Инструкция по настенному монтажу и встраиванию

Страница: 13 / 15

Remote Control
DIMMER ON/OFF HIGH
A
Infrared Window
B On/Off Switch
C Flame Effect Dimmer
D Heater Maximum Heat
E Heater Low Heat
1. Prior to use, the remote control handset requires installation of
batteries
(Figure 8 ).
2. Remove the cover on the rear of the remote
batteries as shown and then slide the cover back into the original position.
3. To enable the remote control to function the power to the fire
4. At a distance of 5 to 6 feet, point the remote co
hand side of the fireplace
B On/Off Switch Press on/off switch to turn fire on.
C
Flame Effect Dimmer To operate press once to commence dimming cycle. During the
dimming cycle the fire will slowly
level. Press a second time to stop cycle when the desired brightness level is obtained.
Failure to press dimmer a second time will result in the fire dimming then brightening
repeatedly.
HIGH\LO W
Prior to use, the remote control handset requires installation of the two included
Remove the cover on the rear of the remote control by sliding backwards. Install the
batteries as shown and then slide the cover back into the original position.
To enable the remote control to function the power to the fireplace must be switched on.
At a distance of 5 to 6 feet, point the remote control directly towards the bottom right
place. ( Figure 9 )
Press on/off switch to turn fire on.
To operate press once to commence dimming cycle. During the
cycle the fire will slowly dim then brighten allowing user to choose suitable
level. Press a second time to stop cycle when the desired brightness level is obtained.
Failure to press dimmer a second time will result in the fire dimming then brightening
12 | P a g e
the two included AAA
by sliding backwards. Install the
batteries as shown and then slide the cover back into the original position.
must be switched on.
ntrol directly towards the bottom right
To operate press once to commence dimming cycle. During the
dim then brighten allowing user to choose suitable
level. Press a second time to stop cycle when the desired brightness level is obtained.
Failure to press dimmer a second time will result in the fire dimming then brightening