9. Feedback during a performance is usually caused by one of the monitors. The
main PA is less likely to feed back because the mics are so far away from the
main PA speakers. Therefore, if you are using monitors and feedback occurs, try
the following procedures:
i.
Turn the
MONITOR
master down until the feedback stops.
ii. If you have a graphic equalizer patched between the
MONITOR
output
and your monitor power amp, pull down one or two (but not more) of
the
EQ
sliders in the frequency range where the sound seems to be
occurring.
iii. Now turn the
MONITOR
master back up. If the feedback recurs, push
the
EQ
slider/s back up to center position and try pulling down one or
two others.
iv. In the rare case of main system feedback, follow the above type of
procedure, but using the
MAIN
master and the built in
GRAPHIC EQ
.
FEATURES
9
MIXER
Balanced XLR inputs
8
Balanced ¼" inputs
6
Unbalanced RCA inputs
2 pairs
Channel Equalization
High, Mid, and Low
Channel Effects Send Control
YES
Channel Effects
Post Channel EQ
Monitor Sends
Pre-Gain
Digital Internal Effects
255 Presets
Main Out/Amp In
YES (Mono) / YES
Monitor Out/Amp In
YES / YES
Main EQ
9 Band, graphic
Monitor EQ
5 Band, graphic
Effects Send/Footswitch
YES
Effects to Main
YES
Effects to Monitor
YES
Record Out
YES
Phantom Power
24 VDC
Dimensions
(D/W/H) 10" x 21" x 11.85"
(D/W/H) 25cm x 55cm x 30cm
Weight
38 lb. (17.5 kg.)
AMPLIFIERS
Rated Load Power
MAIN 400 Watts into 4 Ohms
MONITOR 200 Watts into 2 Ohms
Total Harmonic Distortion
<0.01%
Signal to Noise Ratio
MAIN 101 db, MONITOR 105 db
POWER REQUIREMENTS
North American
117 VAC 700 W VA 60 Hz
European
230 VAC 700 W VA 50 Hz
