S t a g e L i g h t i n g
LP-C4
2
B
LaCkOut
S
witCh
Step on this switch to immediately shut off all lights connected to the LP-C4. The
Blackout LED will light when the controller is in blackout mode. Step on the switch again
to revert to the previously selected scene or effect. Alternatively, you can step on a
Scene/Effect switch to exit blackout into the scene or effect of your choice.
Note: The Function Switch stays active in Blackout mode so you can change modes
before you exit Blackout.
S
CeneS
The LP-C4 can store six custom scenes. To create a scene, press the switch of the scene
in which you would like to store your changes. Select the colors and intensities that you
would like for each of your four channels of lighting. Changes to a scene are stored in
memory as they happen, so you don’t need to do anything to store the scene you’ve cre-
ated. The next time you load this scene, it will come back just as you’ve set it up.
e
ffeCtS
Color fade
– All channels are the same color and fade between colors. These fades are
fairly slow.
Mixed Color Fade
– Similar to above but heads are different colors.
Auto-Sequence
– This effect fades the lights through a factory pre-programmed
sequence of 'scenes.' These are NOT user-programmable and are unrelated to the six
Scenes that you can program and store. It was designed to be a very simple 'set and
forget it' mode.
Note: The three above effects will appear to do nothing when using the LP-302
and LP-304 lighting systems.
Color Chase
– Lights come on sequentially, one at a time. Each time the light advances
a different color is randomly selected.
Audio Flash all
– All 4 channels are the same color and pulse with the bass beat.
Each time the lights go out the color changes so that the next pulse is a different color.
Strobe
– Just like the name says, this is a strobe inspired effect.
O
utPut
J
aCkS
There are two XLR output jacks on the back of the LP-C4. Both of these jacks carry
identical data for all four channels of the LP-C4 (i.e. they are in parallel).
Specifications
LP-C4
Stage Lighting Controller
Output Channels 4
Scenes 6
Effects 6
Audio Level 75 mV - 100 Volts
Audio Input Impedance 600 k between Tip and Ring. 1.8 k Sleeve to GND
Audio Input Connector 1/4-inch TRS
Data to Lights Connector 3-pin XLR male
Communication Protocol Yorkville propietary 31.5 kBits/s
Power for Controller 24 Volts, provided by Yorkville light fixture
Maximum Cable Length at least 600 ft
Dimensions (DWH) 7.1 inches x 12 inches x 3 inches
18 cm x 30.5 cm x 7.6 cm
Weight (lbs/kg): 3.5/1.6