© 2017 Johnson Controls, Inc.
P5417016
Code No. LIT-12012503
Issued May 2017
Snap the motion sensor kit to the cover ensuring
that the tabs are properly engaged.
(4) After connecting the connecting cable, route it out to inside the false
ceiling or outside of the unit.
Next, route the cable to the installed location of the motion sensor kit.
After running the connecting cable, clamp the extra length of the
connecting cable with the included cable clamp and store it inside the
ceiling.
(5) Pull out the connecting cable 1-15/16 inch
(50mm) from the wiring hole.
(6) Detach the cover of motion sensor kit.
(7) Connect the wiring for motion sensor kit to the relay connector as shown in the following figures.
After connecting the cable, cover the connection to the relay connector. Attach the wiring cover with
the cable clamps.
(8) Install the motion sensor kit to ceiling using
screws while pushing the cable into the hole.
(9) Attach the cover of motion sensor kit as the
following figure.
Connecting Cable
Connecting Cable
Wiring Hole
φ
13/16 inch (20mm)
φ
1-15/16 inch
(50mm)
Cover
Detach the cover by
pushing while holding
in the direction of arrows.
A
A
A
Ceiling
Screw
Motion Sensor Kit
Cover
Motion Sensor Kit
Cover
Enlarged View
Wiring Hole
(
φ
13/16 inch (20mm))
Connecting Cable
Motion Sensor Kit
Cable Clamp
Cable Clamp
Wiring Cover
Relay Connector
