16
When The Unit Is Not To Be Used For An Extended Long Period Of Time
Operate the unit for
2 hours with the
following setting.
Operating mode : cool
Temperature : 30°C/86°F
Remove the power plug.
If you are using an
independent electric
circuit for your unit,
cut off the circuit.
Remove the batteries in
the remote control.
If any malfunction of the air conditioner unit is noted, immediately switch off the power
supply to the unit. Check the following fault conditions and causes for some simple
troubleshooting tips.
Causes / Action
-
Protection against frequent starting. Wait
for 3 to 4 minutes for the compressor to
start operating.
-
Power failure, or the fuse need to be
replaced.
-
The power plug is disconnected.
-
It is possible that your delay timer has
been set incorrectly.
-
If the fault persist after all these
verifications, please contact the air
conditioner unit installer.
-
The air filter is dirty.
-
The doors or windows are open.
-
The air suction and discharge are clogged.
-
The regulated temperature is not high
enough.
-
Odours may be caused by cigarettes,
smoke particles, perfume etc. which might
have adhered onto the coil.
-
This is caused by air humidity after an
extended long period of operation.
-
The set temperature is too low, increase
the temperature setting and operate the
unit at high fan speed.
-
Switch off unit and call dealer.
-
Refrigerant fluid flowing into the
evaporator coil.
Fault
1. The compressor does not operate
3 minutes after the air conditioner unit
is started.
2. The air conditioner unit does not
operate.
3. The air flow is too low.
4. Discharge air flow has bad odour.
5. Condensation on the front air grille of
the indoor unit.
6. Water flowing out from the air
conditioner unit.
7. Hissing air flow sound from the air
conditioner unit during operation.
If the fault persists, please call your local dealer / serviceman.
TROUBLESHOOTING
