York D4IC-360, Техническая информация, Страница: 7 / 64

7
the outdoor coil.
On units with several compressors, it cannot defrost two
circuits at the same time.
3.19.- Transportation and handling
Suspend the unit by the 4 points provided, using chain or
cable slings (Fig. 1) and spacers longer than the width of the
equipment. Do not use forklift trucks.
Typical elevation
3.20.- Location
Use the following guidelines to select an adequate location
for these units.
1. This equipment is designed for outdoor installation only.
2. The condenser requires an unlimited air supply. Whenever
possible to choose a location, locate the equipment on
the north or east side of the building.
. For ground level installations, use a level concrete slab
of at least 100 mm. thick. The length and width should be
at least 150 mm. more than the base beams of the units.
Do not fasten the bed frame to the foundation of the build-
ing.
4. For rooftop installation, the roof structure should be able
to support the weight of the equipment, its options and/
or accessories. The equipment should be installed on a
mounting base or on an adequate frame of steel angles
(the optional accessory "mounting base" or "Roof Curb"
is available).
5. Maintain a maximum 10 mm. level tolerance along the
entire length and width of the equipment.
Attention:
The roof of the unit is tilted slightly to drain rainwater.
Never check the level of the unit along the width of same and
using the roof of the unit as a point of reference.
Use the base of the unit as a reference (Fig. 2).
Note:
See Physical Data table for unit
weight, basic unit + accessories
installed
- Fig. 1 -
- Fig. 2 -
(X4)
SHACKLE
SPACER BARS
OK