into slots in the back of the duct openings and
screwing them to the base of the unit with screws
(Use screws removed from original panel location.).
Seals around duct openings must be tight.
CAUTION
When fastening ductwork to side duct flanges on unit,
insert screws through duct flanges only. DO NOT
insert screws through casing. Outdoor ductwork must
be insulated and water-proofed.
Figure 17: Side Duct Cover Panels
Note:
Shown with duct connection cover panel
as shipped.
Figure 18: Bottom Return Opening For Side Duct
Conversion
Figure 19: Bottom Supply Opening For Side Duct
Conversion
Condensate Drain
A side condensate drain is provided to facilitate
condensate piping. A condensate drain connection
is available through the base pan for piping inside
the roof curb. Trap the connection per Figure 20.
The trap and drain lines should be protected from
freezing.
Plumbing must conform to local codes. Use a
sealing compound on male pipe threads. Install
condensate drain line from the 3/4 in. NPT female
connection on the unit to an open drain.
Figure 20: Condensate Drain
INSTALLATION MANUAL ZX SERIES 6 - 12.5 Ton 60 Hertz R-410A
21
Johnson Controls Ducted Systems
Содержание ZX Series
