The channel is inactive when its number is flashing. Default channels are active in automation. This applies to
a 5-channel transmitter.
1. Manual work mode (MAN symbol will display): standard mode without using time programming function.
2. Automatic mode (AUTO symbol will display): standard mode with activated automatic work time.
3. Random work mode: mode with random time of activation (+/- 15 minutes difference from programmed time).
Time can be set only when device is in manual working mode.
Longer than 10 seconds pause between series of button clicks during programming will cause device to switch off
from time setting mode.
By pressing work mode button
for about 3 seconds work mode
set to manual mode.
Press and hold L1 button
for about 3 seconds
(hour starts to flash).
Using UP and DOWN
buttons set hour.
By pressing L1 button
switch to minute setting.
Using UP and DOWN
buttons set minute.
By pressing L1 button switch
to current day of the week.
Using UP and DOWN
buttons set current
day of the week.
Press and hold P1 button
for about 3 second to confirm
all the changes.
Pressing ‘L1’ button
will start the clock.
By pressing work mode button
for about 3 seconds
set the manual mode.
By pressing work mode button
for about 3 seconds set the
automatic mode.
By pressing work mode button
for about 3 seconds
set the random mode.
Pressing the programming
button P2 again switches
between modes.
Press work mode button to
change automatic or
random mode.
By pressing ‘L1’ or ‘P1’
choose a channel.
By pressing
‘P1’ button for about 3 seconds
automatic mode is deactivated
Channel number is flashing.
Another pressing ‘P1’ button
for about 3 seconds
will activate automatic mode
Channel displays constantly.
2
3. Activating channels in automatic mode
4. Changing work mode
5. Setting current time
1. The programming button replaces the simultaneous pressing of the work mode button and L1 timer programming
button.
2. Group channel is active when all numbers are selected
4. Estimated battery lifespan is 3 year if the device runs 4 commends a day in average.
5. Batteries should be changed when no channel number is displayed after pressing any button or receiving device stops
reacting to commands.
When replacing the battery, pay attention to the correct polarity
Batteries contain substances that may be hazardous to health and may pollute the environment. Used batteries should
be disposed of properly.
