1. Control:
possibility to control 1 motor or a group of up to 20 motors on each channel
2. Range:
up to 200 meters in open area,
up to 35 meters indoors
3. Battery:
CR2450
4. Power supply:
3 V
5. Dimensions:
130 x 45 x 12 mm
6. Signal power:
10 mW
7. Operation temperature:
from 0°C to 50°C
8. Safety degree:
IP 30
2
Pressing UP or DOWN button causes the exit from the selection of active channels mode.
Perform the following procedure again to change the number of active channels.
3. Selection of active channels
Press and hold C and CHANNEL - buttons simultaneously.
Symbol "C" will appear on the display and after 4 seconds - number 15,
as well as up and down arrows.
Set the number of displayed channels
with C or CHANNEL - buttons.
Confirm the settings with STOP button.
Symbol "o" appears on the display.
1. Programming of a transmitter depends on the type of receiver. While programming you should abide by the manual
of the device, that the transmitter is supposed to control.
2. A break between succesive button presses longer than 6 seconds, will automatically cause the exit from programming mode
without saving the changes.
3. If limit positions have not been set, programming of the first transmitter will delete transmitters that were programmed earlier.
4. If channel "0" is set on the display, the group channel is on. It allows to simultaneously control all blinds that are programmed
on particular channels. Do not perform any programming procedures on this channel. The group channel is created automatically.
-
6. Programming the first transmitter for motors of EV/S type
Turn on power supply or press
the programming button on the cylinder
head (for 2 sec.) if the power supply is on.
Motor will make a sound.
Blind will make short
up/down moves.
Press and hold STOP button
on the remote control for 2 seconds.
Blind will make two short
up/down moves. Motor will make
a few short sound signals.
1. Transmitter can operate in one of two modes:
a) bidirectional
b) unidirectional
2. The transmitter operates in bidirectional mode due to factory settings.
4. Blockage of function keys
5. Transmitter operation mode selection
Take the battery
out of the transmitter.
Press P2 programming
button.
If digit 1 appears on the display, the transmitter
operates in unidirectional mode.
If digit 2 appears on the display, the transmitter
operates in bidirectional mode.
Transmitter has been
programmed.
Put the battery in while holding
P2 programming button.
1. Blockage of function keys prevents accidental pressing of two buttons used while programming motors or radio receivers.
2. This function is disabled due to factory settings. To turn it on/off you need to perform the following procedure.
Press P2 programming button to confirm
turning the blockage of function keys on/off.
If symbol "L" appears on the display,
the blockage function is on.
If symbol "U" appears on the display,
the blockage function is off.
Symbol "o" appears on the display.
Press and hold STOP button
for 15 seconds.
