2
1.To control all receivers by the transmitter run the channel group. The group channel is on when all channels are
highlighted.
2. For devices that are programmed on all channels operate at the programmed time, you should select a group channel
on the transmitter and set the automatic mode.
3. Estimated battery lifespan is 1 year if the device runs 4 commends a day in average.
4. Batteries should be changed when receiving device stops reacting to commands.
5. When replacing the battery, pay attention to the correct polarity.
Batteries contain substances that may be hazardous to health and may pollute the environment. Used batteries should
be disposed of properly.
1. Manual working mode (symbol MAN appear on the display) normal working mode, without timer function.
2. Automatic working mode (symbol AUTO appear on the display) normal working mode with timer function.
3. Random working mode (symbol appear on the display) time controlled work with random opening/closing time
(up to 15 minutes difference to preset opening/closing time).
4. Working mode is changed for all channels.
1.Time can be set only when device is in manual working mode.
2. Longer than 60 seconds pause between series of button clicks during programming will cause device to switch off
from programming mode without saving any changes.
1. Each channel can be activated or deactivated in the automatic mode. If the channel is inactive, the transmitter will not
control the receiver in this mode.
2. The channel is inactive if number of this channel is flashing.
3. Activating channels in automatic mode
4. Changing work mode
5. Setting current time
Press WORK MODE
button to set the
automatic mode.
Use the P1- or P1 +
buttons to set
the channel.
Press and hold the
P1 + button
for 3 seconds.
The number of the selected channel starts flashing,
which means that the channel is inactive in the automatic
mode. Repeating the procedure activates the channel.
Every working mode change results in
switching between the modes.
Press
WORK MODE button
to set the manual
working mode.
Press
WORK MODE button
to set the manual
working mode.
Press and hold
TIME CHANGE button
for about 3 seconds.
Current time flashes
on the screen.
Press
WORK MODE button
to set the automatic
working mode.
Press
WORK MODE button
to set the random
working mode.
Press P1+ button
to switch between
setting hour, minutes
or days of week.
Using UP and DOWN
buttons set current time.
Press TIME CHANGE
button to start the clock .
Pressing and holding the TIME
CHANGE button for 3 seconds we
confirm the changes (the time on
the display will stop flashing).