1. Difference between automatic time of roller shutter opening and closing cannot be shorter than 32 minutes. In case of
smaller than minimal time difference fault message will appear.
2. Changes to opening and closing time can be done only in automatic mode.
3. Longer than 10 seconds pause between series of button clicks during programming will cause device to switch off
from
time setting mode without saving any changes.
4. Group channel needs to chosen for transmitter to control all devices at the same time. That applies to all working
modes.
5. If while setting time of automatic opening or closing ‘--:--‘ symbol appears, it means that this time is not active in
automatic mode.
6. To leave time programming mode without saving any changes press STOP button.
The below steps need to be repeated for all five channels during the same programming.
PERFORMED ACTION
TIME PROGRAMMING FOR OPENING AND CLOSING
DISPLAY MESSAGE
By pressing
programming button P2
for about 3 seconds work mode
will change to automatic mode.
Press
L1 button.
Using UP and DOWN buttons
set hour.
Press
L1 button.
Switch to opening minute setting.
Minute starts to flash.
The set time will
appear on the display
Opening time will display.
Hour starts to flash.
AUTO symbol
will display.
Press and hold L1 button
for about 3 seconds.
Opening time
will display.
AUTO
AUTO
AUTO
AUTO
AUTO
Time can be set only when device is in manual working mode.
Longer than 10 seconds pause between series of button clicks during programming will cause device to switch off from
time setting mode without saving any changes.
By pressing L1 button switch
to current day of the week.
Using UP and DOWN buttons
set current day of the week.
Press P1 button
to confirm all the changes.
By pressing
programming button P2
for about 3 seconds work mode
will change to manual mode.
Press and hold L1 button
for about 5 seconds
(hour starts to flash).
Using UP and DOWN
buttons set hour.
By pressing L1 button
switch to minute setting.
Using UP and DOWN buttons
set minute.
5. Setting current time
6. Changing time settings for automatic opening and closing
7. Setting automatic opening and closing time
3
Su
Mo Tu We Th Fr
Mo Tu We Th Fr
Mo Tu We Th Fr
Mo Tu We Th Fr
